Hippo
Hippo
Low stock: 7 left
Couldn't load pickup availability
Product Care
Product Care
3D printed items are created by heat & as such it's their biggest enemy: no dishwashers, heaters or windowsills or else they may warp.
You can clean them with warm soapy water, a toothbrush & leave to air dry.
None of our items are intended as toys. They contain small parts & may present a choking hazard. Please be gentle with them, keep them away from small children esp those under 3.
Colour
Colour
Every roll of printing filament is a little different - your print will be as close as possible to the photo but there may be some minor variance.
When your print has a gradient, the stripes may fall in slightly different places. If it is important to you to have a colour exactly the same as a previous purchase, please send us an email.
License
License
This design is commercially licensed from Printverse. Cody Rose customises & prints these in regional Australia from specially selected filaments on her Bambu Lab printers.
The sweetest grey cutie this side of the mudbath! Look at that smile!
These hippos are approx 7cm long & stand 5.5cm tall too .
Unlike most our prints, these guys are printed in 2 parts, the head is popped on with a ball joint. This means if intentionally pulled by a very strong person, it could come off. So we strongly recommend reserving them for people over 5 as the heads could present a choking hazard.
For more info, check out tabs above.


Hippo


