Dino [Feathered Velociraptor]

Dino [Feathered Velociraptor]

Low stock

$13.00
$13.00
Save 0% Sold out

Product Care

3D printed items are created by heat & as such it's their biggest enemy: no dishwashers, heaters or windowsills or else they may warp.

You can clean them with warm soapy water, a toothbrush & leave to air dry.

None of our items are intended as toys. They contain small parts & may present a choking hazard. Please be gentle with them, keep them away from small children esp those under 3.

Colour

Every roll of printing filament is a little different - your print will be as close as possible to the photo but there may be some minor variance.

When your print has a gradient, the stripes may fall in slightly different places. If it is important to you to have a colour exactly the same as a previous purchase, please send us an email.

License

This design is commercially licensed from Layers In Green. Cody Rose customises & prints these in regional Australia from specially selected filaments on her Bambu Lab printers.

What if... dino's had feathers (they think they did!) This lil' guys is coloured to honour Mongo from the Dungeon Crawler Carl series but I'm pretty sure we can all agree he's the coolest coloured dino out there regardless!

These lil' ones are approx 9cm long & are a single piece with flexible parts. 

While we don't think they're going to run off to the dungeon, it's probably worth keep them close by just in case...

For more info, check out tabs above. 

View full details